A CO₂ monitor that freezes on a healthy-looking reading is indistinguishable from a dead sensor. William Collis fixed this by redesigning how his two-zone home CO₂ system handles sensor failure, making faults visible instead of invisible.
His hardware is a Sensirion SCD30 paired with a Seeed XIAO ESP32-C3, running ESPHome and reporting to Home Assistant. The critical detail: Collis made no firmware changes. Every modification lives in an ESPHome configuration file, which means the approach is portable and repeatable by anyone running the same stack. A fault now triggers a physical LED flash on the sensor unit itself.
The read is worth your time not for the conclusion but for the configuration logic: how ESPHome handles stale sensor states, and where the boundary sits between a frozen-good value and a silent failure. If you are running any ESPHome sensor that displays a last-known value on disconnect, your setup has the same flaw his did.
[READ ORIGINAL →]